ASAP Home Inspections and Environmental Testing

ASAP Home Inspections and Environmental Testing

Mold Testing and Investigation

Mold Testing Can Save You Money and your Health!

Mold Inspections 

Jim Van Loosen

                                                    Inspector Number  IAC2-02-6528

Complete Mold Inspection

The inspector shall perform:

- a non-invasive visual examination of the readily accessible, visible, and installed systems and components of the building (listed in Section 4.0 Standards of Practice)
- moisture, temperature and humidity measurements (refer to Section 4.8 Moisture, Humidity, and Temperature)
- mold samples according to the IAC2 Mold Sampling Procedures (refer to Section 5.0 IAC2 Mold Sampling Procedures)

The inspector shall report:

- moisture intrusion,
- water damage,
- musty odors,
- apparent mold growth, or
- conditions conducive to mold growth;
- results of a laboratory analysis of all mold samplings taken at the building; and
- any system or component listed in Section 4.0 Standards of Practice that were not inspected and the reason(s) they were not inspected.

Limited Mold Inspection

The limited mold inspection does not include a visual examination of the entire building, but is limited to a specific area of the building identified and described by the inspector. As a result, moisture intrusion, water damage, musty odors, apparent mold growth, or conditions conducive to mold growth in other areas of the building may not be inspected.

The inspector shall describe:

- the room or limited area of the building in which the Limited Mold Inspection is performed

The inspector shall perform:

- a limited non-invasive visual examination of the readily accessible, visible, and installed systems and components located only in the room or limited area (as described in previous Section 3.1).
- mold samples according to the IAC2 Mold Sampling Procedures (see Section 5.0 IAC2 Mold Sampling Procedures)

The inspector shall report:

- moisture intrusion,
- water damage,
- musty odors,
- apparent mold growth, or
- conditions conducive to mold growth; and
- results of a laboratory analysis of all mold samplings taken at the building

ASAP Inspections and Environmental testing Corporation
211 Stevenson Rd N.
Oshawa, Ontario
L1J5M7
Toll Free 855-410-6717

ASAP Inspections and Environmental Testing Corporation
"You Don't Know What You're Missing!"
Hours:

Mon-Fri 8am - 9pm
Sat 9am - 9pm
Sun 9am - 9pm

http://www.asaphi.ca